After the ceiling paint dries, it’s time to paint the walls.

Don't forget about the "fifth" wall!

Being that I have to paint every ceiling in the house and all! Switch from brush to roller to start painting the rest of the ceiling. We’re excited to go ahead and paint the ceiling and walls, since we … Went back and rollered the walls. I knew I needed to find out How to paint ceilings without making a huge mess. Ask Question Asked 4 years, 10 months ago. ... it is relatively easy to exclude the ceiling. ... maroon in the kitchen and lavender in the bathroom. Then move down the wall and start another section. It is easy to repair a paint mishap, whether you need to tidy up a paint job you have just completed or fix a previous paint problem. Does anyone have any tips on spaying the walls after the ceiling without causing over spray on the ceiling. Because gravity is your enemy as you work to complete this task, you must constantly fight against it. Start from the corner of the ceiling and start rolling nearest to a window, so that you can see the light from the window reflecting the wet paint. I decided to buy an airless sprayer after having renting them so often. Simply spray the ceiling, and let overspray land on the wall and ceiling trim. Find out the easiest way to DIY prime and paint a kitchen or bedroom ceiling and its edges white or another color. Next, if your ceiling has stains, remove the duct tape and dampen the roller with a little bit of water. Tap it on the sides of the bowl. Knowing How to Paint a Ceiling Without Getting Paint on Walls. To clean a popcorn ceiling, first wrap a paint roller in duct tape, with the sticky-side of the tape facing up. Cover the edges with quick-release masking tape and paper -- to avoid getting overspray on the ceiling -- and start spraying the walls. If your ceiling is highly textured, for example if it is a popcorn ceiling, you can't tape it off for painting. At corners, where ceilings meet the walls, highly important having sharp crisp transition lines, without dripping or splattering, getting paint on walls, after painting your ceilings. Well Carl, it goes without saying that ANY spray job done with a shield is going to end up with some touchup...Thing with ceilings is that, considering the lack of absolute straight joints and what I've noticed to be a negligence of most drywall guys to score the wall-to-ceiling joint consistantly or at all, transient overspray would make it necessary to repaint the ceiling anyway. Shake out the brush before using it. With Rust-Oleum Dry Erase paint, you can encourage it. There is no need to use masking film on the ceiling when rolling walls. When you place the pad along the top of the wall so the wheels roll on the ceiling, you’ll be able to paint a perfect line. Roll or Spray First. The walls took me forever so im trying to not put tape on anything. These and any other surface blemishes tend to show when using any other kind of paint so you lose that perfect ceiling look of matte ceilings. Smooth out the cut-in area by lightly brushing the tip of the bristles over the newly painted area to create a feathered edge. Hold the trimmer at the top of the wall in one hand and spray the paint back and forth under it until you are far enough away from the ceiling that the spray will not get on it.